Raspberry Pi Zero Console Case – Slim Clear

Description

This is a *name, brand or logo customized basic, classic Pi Zero enclosure with a black base and a clear top. The case has two pieces of polycarbonate that snap snugly together. This case will keep your Pi Zero safe and secure while also looking super sleek. You can use all of the connectors on the edges of the Pi: mini HDMI, microSD slot, microUSB power, and microUSB port. There’s also a cut out to allow a 2×20-pin header to be soldered onto the Pi Zero.

The enclosure was designed by Adafruit’s Mike Doell Made of ultra-durable, super-glossy polycarbonate, it is both good looking and tough enough to toss into your pocket, bookbag, or toolbox. It has slim openings for all your cables, an easy-to-access slot for your Micro SD card, slots for your Pi Camera, and a space for your GPIO cable to extend out from the Pi.

*Free Custom Laser Etched name or logo (x5 Min Order)

The Pi sits nicely in the base, latching to the corner pegs, and the lid fits snugly on top. If you want to break-out your Pi you can simply snap off the GPIO slot and add pHATs, Bonnets, GPIO cables, and other accessories with ease.

• Main Features:
• High-quality material, very durable
• Access to all Pi Zero consumer ports
• The Raspberry Pi Zero not included.
• It has a snappy secure fit and locks together with 2 screws
• It requires a raspberry pi zero.

Once the console cable circuit board is clear, cut the cable to about 4-5 inches long and you can pull the wires (carefully) to get them out of the rubber cable cover. Then solder the wires into the pi-zero holes and everything is press-fit into the housing. The pi-zero should go down with a small amount of pressure (snapping in) and the console circuit board snaps into the obvious area. The USB connector fits snugly and holds the console circuit board well.

Then just snap the two pieces of the box together and srew together.